Introduction to the Automobile Demonstrating Board for Passat B5
This training bench uses a Passat based on the entire vehicle’s
electrical physical and supporting auxiliary systems to completely
demonstrate the vehicle’s electrical structure and operation. It is used
for vehicle electrical theory teaching, practical operations, fault
diagnosis and teaching settings in the higher vocational colleges and
training institutions.
Basic Configuration of the Automobile Demonstrating Board for Passat B5
Engine control unit,
Combination instruments
Throttle body
Left front window motor
Right front window motor
Left front lock block
Right front lock block
Left rear window motor
Left rear lock block
Right rear window motor
Right rear lock block
High low horn
Rear view mirror switch
Left rear view mirror
Right rear view mirror
OBDII diagnosis port
Ignition switch
Combination switch
Comfort system control unit
Wiper motor
Water pump
Battery
Sound system
Left head lamp
Right head lamp
Relay and fuse box
Measurement plate and moving bracket
Supporting manual
Training guide book
Features of the Automobile Demonstrating Board for Passat
1. Fully demonstrate the entire vehicle’s electrical system structure
composition and operation so that students get a more intuitive
understanding of the entire vehicle’s electrical connections.
2. Through a variety of electrical switches and buttons on the
demonstration board, a real demo works for the car engine immobilizer
systems, instrumentation systems, lighting systems, wiper systems,
speaker systems, ignition systems, electric windows, power door locks,
sound system, start system and charging system.
3. Training benches are equipped with full- vehicle color schematics
and detection terminals, sensors, actuators, and other signal parameters
such as voltage, resistance, and frequency, all of which can be
detected using special instruments.
4. Training benches are equipped with diagnostic blocks that can be
connected to a dedicated or universal car decoder for reading the
electrical fault codes, clear fault codes, read data stream, actuate
components test, parameter settings, and waveform analysis. They also
feature a self-diagnostic function.
5. Fault setting and appraisal system: use fault setting box set to
manually or delete single and combination fault, including all the
sensors, actuators and controller faults. (Fault setting types:
disconnection, short circuit, and virtual connection). Turn the fault
switch to the original position and the fault is deleted. Users can set
any recombination fault and delete the fault. Using a concealed fault
setting is convenient for testing students. Instructors can set various
hard emulating faults in the sensors and controlling unit (Example:
magnetic, thermosensitive, pressure-sensitive, photoelectric, and
electromagnetic), and the fault type can be set as a signal distortion
or accidental fault.
6. The training board is assembled with a protection cover.
7. Mobile device with locking casters, allowing it to move freely and facilitate teaching.
Training Content
1. Automobile electric component parts of each system and control theory project training
2. Automobile instrumentation systems, lighting systems, wiper
systems, speaker systems, sound system, ignition system, electric window
system, electronic locking system, starting system, charging system
project training
3. The training of using a multimeter or oscilloscope measures the voltage, resistor, and signal of the circuit components
4. Automobile electric system schematic diagram analysis training
5. Automobile electric control unit fault code reader, clear DTCs, read
data stream programming, terminal component test project training
Technique Feature of the Automobile Demonstrating Board for Passat B5
1. Auto type: Passat B5 (custom-made)
2. Input power: AC 380V±10% 50Hz 220V±10% 50Hz（single phase）
3. Working power: DC12V
4. Three phase asynchronous motor:
type：Y100L1-2
voltage：AC 380V
power：2.2KW
current：5.0A
rotary speed：1430r/min
5. Working environment temperature: -40℃～+50℃
6. Dimensions: 2400×850×1820mm mm
7.the bracket weld by high quality material, powder coating
ISO 9001:2015
