Code: ETOPM10291
HYDRAULICS BENCH.
DESCRIPTION
The hydraulic bench represents a service unit for a wide variety of complementary accessories that enable to perform several experiments of fluid mechanics. The upper part of the bench consists of a work top equipped with an open channel above which the accessories are placed, and of two tanks that enable to carry out some volumetric measurements of the flow rate by using a level gauge. The bottom of the volumetric tank
is equipped with a valve in order to drain the water in the supply tank. The water is drawn to the top of the bench by a centrifugal pump, whereas the flow rate is adjusted through a control valve and measured with a variable area flowmeter.
The variable-area flowmeter enables to compare the flow rate read on the instrument with the flow rate measured through the measuring tanks.
TRAINING PROGRAM:
• Volumetric measurement flow rate
• Calibration of a variable area flowmeter
• Characteristic curve of a centrifugal pump
TECHNICAL CHARACTERISTICS:
• Hydraulics bench built completely in AISI 304 stainless steel (frame, tanks, valves and pipes) and mounted on wheels with brakes
• Centrifugal pump of stainless steel - 0.37 kW, maximum flow rate of 80 l/min, maximum head of 20 m
• Pressure gauge on the section and on the discharge of the pump Capacity of the supply tank: 120 litres
• Variable-area fl owmeter, range 0,4-4 m³/h
• Upper tank for volumetric fl ow measurement with 10 litres capacity (for low flow rates) and with 40 litres capacity (for high flow rates)
• Control valve for adjusting flow rate
• Drain valve on the base of the upper tank for water recycling inside the supply tank
• Work top with open channel
Power supply: 230 Vac 50 Hz single-phase - 0.6 kVA
(other voltage and frequency under request)
Dimensions: 760 × 1230 × 1180 (h) mm
Weight: 130 kg
SUPPLIED with THEORETICAL-EXPERIMENTAL HANDBOOK