Code: ETOPM10573
MULTI-PROCESS CONTROL.
INTRODUCTION
This bench top unit enables to carry out tests on the control
of fl ow rate (of air and water), level, temperature and pressure
on the same controller (a control at a time), and to modify the
hydraulic circuit via manual valves.
A SCADA software enables to control the unit from a PC and to
assess the system responses to noises.
TRAINING PROGRAM:
This unit enables to develop and analyze the following subjects:
• Proportional, Integral and Derivative control
• Control of
- fl ow rate
- level
- pressure
- temperature
• Tuning techniques of the controller
TECHNICAL CHARACTERISTICS:
• Framework of AISI 304 stainless steel
• Variable-area fl owmeter with range of 0 to 1000 l/h
• Graduated tank of Plexiglas with capacity of 5 litres
• Plate-type exchanger of stainless steel
• Pneumatic control valve of AISI 316 stainless steel, Cv = 0.25
• Pneumatic control valve of AISI 316 stainless steel, Cv = 0.13
• 2 electro-pneumatic converters, 4 to 20 mA / 0.2 to 1 bar
• Safety valve
• Differential-pressure transmitter of AISI 316 stainless steel
with range of 0 to 500 mm H2O
• Pressure transmitter of AISI 316 stainless steel with range of 0 to 6 bar
• Pressure gauge for measuring the output signal of I/P
converter
• Hot water generator with tank of AISI 304 stainless steel,
electric heating system, recirculation pump of AISI 304
stainless steel and thermostat
• Piping and valves of AISI 304 and 316 stainless steel
• Switchboard of painted carbon steel with synoptic, ELCB
and measuring terminals for input and output signals of the
controller
Power supply: 230 Vac 50 Hz single-phase - 3,5 kVA
(Other voltage and frequency under request)
Dimensions: 850 x 800 x 750 mm
Weight: 50 kg
Supplied with THEORETICAL-EXPERIMENTAL HANDBOOK, ACCESSORIES AND SOFTWARE