Solar Measurement Trainer Module with Artificial light source Trainer.
Technical Description of the Trainer Module
The Module must include the following descriptions or functions:
investigate physical behavior of PV application under a variety of effects such as
illuminance, temperature, shading
Familiarization with key parameters such as short‐circuit current, open‐circuit
voltage, current at maximum output, voltage at maximum output
Relationship between module tilt, illuminance, short‐circuit current and electrical
output
Recording a module's current‐voltage curve
Determining efficiency
Connection types for the modules: series connection, parallel connection
How cells covered by shadow affect the current‐voltage curves
Trainer for solar module measurements
Two pivoting solar modules on mobile frames
Series and parallel connection options
Slide resistor as variable load
Two power resistors for expanding the measuring range
Measuring unit with digital displays for current, voltage, illuminance and module
temperature
Reference cell as illuminance sensor
artificial light source, comprising 2 vertical rows of 4 halogen lamps, operable via
main switch and with halogen lamps with adjustable tilt angle

1.2 Technical Specification of Trainer Module
The Module must include the following technical specifications:
Module design: number of cells 36, cell material: Mono crystalline silicon, module
area: 0,64m²,
Typical module parameters under STC (Standard Test Conditions):
Max. output 85W, short‐circuit current: approx. 5,3A , open‐circuit voltage:
approx. 22V ,
Slide resistor: 0...10 Ohm
Two power resistors: 22 Ohm / 50W
Measuring ranges:
temperature: 0...100°C
voltage: 0...200V
current: 0...20A
illuminance: 0...3kW/m²
tilt: 0...90°
Dimensions and Weight of the solar panel:
LxWxH: approx. 1410x795x1490mm and Weight: approx. 65kg
Connections of module: 230V, 50Hz, 1 phase or 120V, 50Hz, 1 phase
Scope of Delivery:
1 trainer for the solar measurement module
1 slide resistor
1 measuring unit
1 set of cables
1 inclinometer
1 set of instructional material
The Artificial light source must include the following technical specifications:
Artificial light source design:
2 vertical rows of 4 halogen lamps, operable via main switch and with
halogen lamps with adjustable tilt angle
Dimensions and Weight of the Artificial light:
LxWxH: approx. 1350x800x2200mm and Weight: approx. 121kg
The artificial light Power: 8x 1000W
Connections of Artificial light: 400V, 50, 3 phases or 230V, 50Hz, 3 phases
Scope of Delivery:
1 trainer for the artificial light source